CalAmp's planar array transceivers provide the clean, highly directive radiation patterns demanded by two-way networks, in a small, aesthetically pleasing package that can be used in residential installations.
| Downconverter Specifications |
| RF Input Frequency | 2500 - 2686 MHz |
| IF Output Frequency | 222 - 408 MHz |
| Gain | 28 ± 6 dB |
| Noise Figure | 4.5 dB Typ.; 6.0 dB Max at upper end of band |
| Image Rejection (PCS Band Inclusive) | 80 dB Min (60 dB is pre-LNA) |
| WCS Rejection | 80 dB Min (35 dB is pre-LNA) |
| Out of Band Rejection (Minimum) | 15 dB @ 2705 MHz; 40 dB @ 2750 MHz; 40 dB @ 2450 MHz |
| Upconverter Specifications |
| IF Input Frequency | 14.375 - 26.375 MHz |
| RF Output Frequency | 2150 - 2162 MHz |
| Gain Set | 21 to 26 dB (Gain flatness inclusive, full band) |
| Output Power Blanking Threshold | -45 dBm Min @ IF input |
| Antenna Specifications |
| Gain | 17 dBi ± 1 dB |
| 3 dB Beamwidth | 18.5° ± 1.5° |
| 1st Side Lobe (relative to main beam) | 17 dB max, 20 dB Typ |
| General Specifications |
| Rx Phase Noise | -65 dBc/Hz @ 100 Hz; -93 dBc/Hz @ 10 KHz |
| LO Frequency | 2278 ± 10 KHz over temperature |
| Cross polarization | -30 dB Max |
| Pattern Interference Rejection (>60°) | 20 dB Min; -85 dBc/Hz @ 1 KHz; -98 dBc/Hz @ 100 KHz |
| IF Connector | F-Type, 75 Ohm |
| DC Supply | 16 to 24 volts DC @ 550 mA |
| Physical Size | 13.5 x 13.5 x 2.6 in. |
| Physical Weight | 6 lbs. (with mount) |
| Operating Temperature | -30°C to +60°C |
